After a successful installation, I could do little else other than add a new user. Unknown device rev b0.
The wireless should be supported by the ath9k driver under your kernel. I looked at the router log and so no entries that atttansic be associated with the disconnect episodes, but there sure are a lot of sites hitting on my router’s firewall and generating “intrusion” msgs.
Well, the problem seems to have faded away. Probably half my traffic is by IPv6.
attanssic Find More Posts by jschiwal. Email Required, but never shown. I’ve seen a few folks post complaints about the driver for the Marvell Ethernet NIC and even some modified source code. My system is now as fast as ever and has been so every since I booted up the 3. Here is what the hardware probe thought this was: This will display the manid code.
Unknown device rev b0 Hi all I am having problems with my ethernet port on both Hardy and Gutsy: Recompile your kernel with the proper driver, either built in or as a module.
I checked the kernel.
Suse no eth0: Attansic gigabit ethernet
Ubuntu lists the card as Attansic and Windows Vista lists it as Attansic. But what mystifies me is that I’ve had Precise running on the little guy since Aprilwhile the problem I’m having just began to appear last month.
I may have Windstream check my router from their end. Good job and thanks for posting so the searchers can learn from your experience.
CONFIG_NET_VENDOR_ATHEROS: Atheros devices
Originally Posted by reed9. So, perhaps my atl1c driver is not the flaky culprit I thought it was.
Downloads Support Community Development. Last edited by AK; at It refers to the first detected network card in your system. The kernel detected the card but doesn’t have a driver for it. Unknown device rev b Do you have the headers and ‘build-essential’ installed? I have included the output from: By joining our community you will have the ability to post topics, receive our newsletter, use the advanced search, subscribe to threads and access many other special features.
It’s bleeding edge so there might be bugs, but should be usable. Look here on instructions how to enable this: For several months I have been connecting to my eth0 port via a short piece of cat5 cable, since my router is only two feet from my computer.